L298P Motor Driver Shield

L298P Stepper Motor Driver Shield H-bridge

Description:

The dedicated high power motor driver chip L298P can directly drive 2 DC motors up to 2 Amps

8 high speed Schottky diodes at motor output for circuit protection

L298P Shield can be mounted on your Arduino

Pulse Width Modulation (PWM) speed control mode; dual high power H-bridge driver

Driver side Input voltage VS: VIN Input 6.5 - 12V, PWRIN 4.8 - 35V input

Specification:

Logic side input voltage VD: 5V

Driver side input voltage VS: VIN Input 6.5 - 12V, PWRIN 4.8 - 35V input

Logic side working current :<36mA

Driven side operating current Io:<2A

Maximum power dissipation: 25W (T = 75 C)

Control signal input level: High 2.3V<Vin <5V, low -0.3V <Vin <1.5V

Working temperature: -25 + 130 Celsius

Hardware interface: 5.0mm pitch terminal

Belt clip and can be controlled via front row access signal

Pin occupancy: D4 ~ D7 direct drive motor

Supports PWM / PLL mode motor speed control

- Dimensions: 68x 53mm/ 2.68x 2.09inch