3D Printer Controller For Arduino Boards RAMPS 1.4 Reprap

RAMPS shield V1.4

The RAMPS 1.4 board is designed to fit the entire electronics needed for a RepRap in one small package for low cost.
RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty room for expansion.
The modular design includes plug in stepper drivers and extruder control electronics on an Arduino MEGA shield for easy service, part replacement, upgrade-ability and expansion.
Additionally, a number of Arduino expansion boards can be added to the system as long as the main RAMPS board is kept to the top of the stack

This is great way to get started into the exciting world of 3D printing and 2D milling. Creating your own printer was cumbersome in the past, large expensive drivers and limited software to share. That has all changed with the open source world! 

•  Heater/fan output/three thermistor MOSFET.
•  Integrated 5A extra safety and components protection.   Suitable for 5 stepper driver plates.
•   Plate pin socket.
•   I2C/SPI pin for future development.
•   All MOSFET with PWM pins.
•   Servo connector used to connect end dog, motor and lighting diode. Rated current 3A.
•   SD card add Kliment-Sdramps.
•   LED indicates heater output.
•   Two motor connects to Z Prusa Mendal.
•   Size: 11.5cm x 3cm.