HighPi Pro 5S Case for Raspberry Pi 5

No Tools Needed!

The HighPi case is the gold standard in Pi cases for versatility and ease of use. Installing or removing the Raspberry Pi PI$B board is fast, simple, and secure.all without tools or assembly. One snap action locks the Pi board into the case; the second secures the lid, rattle free. Remove the Pi board and the lid with one-finger-releases for each. Genius! Customers assembling large volumes of Pi boards in cases love how much time and effort this case saves them.

The HighPi case can be wall mounted horizontally with two screws for easy removal, or mounted in any orientation including upside-down with four screws from inside the case. When wall mounted horizontally, the A/V and audio cables hang downward from the Pi, improving visual tidiness and reducing the need for support of heavy cables.

FITS LOTS OF HATS

Piles of room inside allows the addition of HATs and break-out boards. Vented on 3 sides doubles as cable ports for the GPIO cables. A 2 section breakout allows you to choose how much of the A/V side of the case to open up for connectors on attached boards. Examples of the HATs that fit in the HighPi below:

	RASPBERRY PI POE HAT The HighPi case holds the PoE HAT securely. The side and bottom ventilation slots allow the fan to move air in and out of the case.
	HIFIBERRY HATS This case perfectly accommodates the full line of HiFiBerry audio boards. Use one break-out section for DAC+ and Digi+, and both for the Amp+ or DAC+DSP. There is generous clearance around the RCA connectors for bulky, high-end cables.
	SERIAL HAT Do you need to ensure power to your Pi or communicate via serial? Our serial HAT can be enclosed tidily along with the Pi board.
	UPS HAT The UPS HAT and Pi board are both enclosed easily in the HighPi case, with significant space for larger batteries. The GPIO connector pins remain accessible, and a GPIO ribbon cable can be run out of the case while fully assembled.

HIGHPI CASE FEATURES

• High quality ABS plastic case, made in Canada
• Ease of use, fast assembly and disassembly without tools!
• Piles of room inside for HATs and breakout boards.
• Vents on 3 sides double as fly thru cable ports
• 2 section break-out on A/V side for HAT board I/O
• Large vent opposite A/V side for GPIO ribbon cable  to pass through
• Micro SD access port
• Mounting option 1: two M3.5/M3/#6 screws slide into wall mounts
  for easy removal, horizontal orientation with A/V side down, 40mm spacing
• Mounting option 2: four M3.5/M3/#6 screws through feet from inside for
  secure mounting in any orientation, 68.3 x 38.8mm spacing
• Self adhesive rubber feet included, set of 4
• Matte finish (hides fingerprints)

• External dimensions: 97 x 66 x 41mm
• Internal dimensions: 90 x 60 x 28.8mm