USB-C Decoy/Emulator Supports output voltages 5V 9V 12V 15V 20V from USB C PSU

Supports Fast Charging Protocol

• PD2.0/PD3.0, QC2.0/QC3.0, AFC

Support Voltage

• 5V, 9V, 12V, 15V, 20V (stepping voltage is not supported)

Voltage Adjustment Method

According to the table on the back of the board, adjust the dip switch to control the voltage output.

Note

• After adjusting the dipswitch, since there is no voltage indicator, it is recommended to use a multimeter to measure the voltage before connecting to the application circuit.
• If the dipswitch is not adjusted according to the table, the module will output any one of the above voltages.