1200W 20A DC Converter Boost Step-up Power Supply Module

Input Voltage: 10-60V / OUT 12-83V

Adjustable voltage and current charging module

Product Description

Large heat sink , supports a wide input voltage 10-60V, 12-83V wide adjustable output voltage, low dropout voltage.
Uses four 63V / 470UF high-frequency low-impedance electrolytic capacitors, output 3 100V / 470UF electrolytic capacitor.

33mm Super Power Kool magnetic ring with three 1.2MM of copper wire and wound to prevent magnetic saturation temperature of the flow through the case.
The 4 rear where two high-power tube is 140A / 100V current switching power MOS two 30A / 100V freewheeling Schottky.
Two aluminum heatsinks and 5015 fan with mounting holes.

Continuously adjustable import power management chip output voltage and current.
Can be used in parallel if you need more power, like output to 30A.

Specifications

non-isolated step-up module (BOOST).
Input voltage: 10-60V.
Input Current: 20A.
Quiescent current: 15mA (12V liter 20V, the output voltage, the higher the current will increase too quiet).
Output voltage: 12-80V continuously adjustable.
Output Current: 20A MAX, more than 12A, for heat dissipation (input, output pressure related, the greater the pressure the smaller the output current).
Constant Range: 0.3~20A.
Output Power:=Input voltage * 20A, such as: input 12V * 20A = 240W, input 24V * 20A = 480W. input 36V * 20A = 720W, input 48V * 20A = 960W, input 60V * 20A = 1200W.
Working temperature: -40 to + 85 degrees.
Operating frequency: 150KHz.
Conversion efficiency: up to 95% (efficiency and input and output voltage, current, pressure related).
Overcurrent protection with reduced flow adjustment, adjustable output current limit, current exceeds the current limit, the output current is automatically reduced to a minimum 5A, variable.
Short circuit protection (input 30A fuse) double short circuit protection.
Input reverse polarity protection: None, (if necessary, please enter the string into the diode).
Output Counter filling for charging plus blocking diode is not required.
Installation: four 3mm screws.
Solderless terminals output.
Dimensions: 85mm(length) * 63mm(width) * 64mm(height).

Specifications

• Input Voltage: 6V to 40V DC(10V to 40V is suggested)
• Output Voltage: 1.2V to 36V DC
• Output Current: 20A(max.), 15A(suggested)
• Efficiency: 95%(24V to 12V, 20A)
• Output Ripple: ≤50mV
• Wiring Method: Terminal
• Short Circuit Protection: Self-recovery(cannot short circuit for long time)
• Size: 60 x 53 x 27mm / 2.36 x 2.08 x 1.06"
• VO+: Output positive
• VO-: Output negative
• +IN: Input positive
• -IN: Input negative
• CV: Output voltage adjustment
• CC: Output current adjustment
• EN: Enable, low voltage level shut off output; suspension, high voltage level is effective
• When input and output is common grounded, no-load CV output constant voltage,CC output constant current