PCF8591 ADC DAC AD/DA Analog Digital Converter Module

SKU
PCF8591AtoD
In stock
$3.95
-
+
Overview

PCF8591 Analog to Digital Converter Module with cable

Product Description

The PCF8591 is a 8-bit CMOS data acquisition device. The PCF8591 has the four analog inputs, one analog output and a serial I2C bus interface. PCF8591 has three address pins A0, A1 and A2 that can be used to set the I2C hardware address, 8 PCF8591 could be on the same I2C bus, without the need for additional hardware. On the PCF8591 control and data signals are transmitted in serial fashion via the two-wire bidirectional I2C bus.

PCF8591 IC Features

  • Single power supply
  • PCF8591 operating voltage range of 2.5V-6V
  • Low standby current
  • Via I2C bus serial input / output
  • PCF8591 by 3 hardware address pins addressing
  • PCF8591 I2C bus speed sampling rate decided
  • 4 analog inputs programmable single-ended or differential input
  • Automatic incremental channel selection
  • PCF8591 analog voltage range from VSS to VDD
  • PCF8591 built-in track-and-hold circuit
  • 8-bit successive approximation A / D converter
  • 1 analog output DAC gain

Module Features

  • Module uses PCF8951
  • Module supports external voltage input of the 4-way acquisition (voltage input range of 0-5v)
  • The module has an integrated photoresistor connected to one A - D port allowing you access to the precise value of the ambient light falling on the LDR. Disconnect it by removing one of the on board jumpers.
  • The module has a thermistor to measure the precise value of the ambient temperature, remove a jumper to disable.
  • The module also has 1 variable resistor 0-5V volts can be sent to one of the A - D pins (the blue potentiometer adjusts the voltage)
  • Power indicator LED
  • 1 LED connected to the D- A port pin (Digital to Analog pin)
  • Module PCB size: 3.6cm * 2.3cm
  • Standard double panel, thickness 1.6mm, 4 x 3mm holes 

Module interface specification:

One end of the board

  • AOUT chip DA output interface
  • AINO chip analog input interface 0
  • AIN1 chip analog input interface 1
  • AIN2 chip analog input interface 2
  • AIN3 chip analog input interface 3

 The other end

  • SCL – IIC clock interface connected to  microcontroller IO port
  • SDA – IIC digital interface connected to  microcontroller IO port
  • GND – connected to  ground
  • VCC – connected to  3.3v-5v

Four red jumper-cap instruction

  •   P4 – connected to P4 shorting cap, select thermistor access circuit
  •   P5 – connect P5 shorting cap, select photoresistor access circuit
  •   P6 – connected to P6 shorting cap, select 0-5V adjustable voltage access circuit