Start Stop timer with Pause ability

Similar to our VK111 this timer has 2 buttons, one for Start and one for Stop. Using the on board pushbutton you can configure the VK031 for several different methods of operation. Normal Start Stop, Pressing the Start button executes the On Delay, interrupt the cycle at anytime by pressing stop. Pausable Start Stop, press the Start button to close the relay contacts, press Start again at any time to pause the delay, pressing Stop clears the delay and waits for the Start button to be pressed, starting a new cycle. Pressing the Start button again closes the relay contacts and continues with the delay remainder. This is a new product as of early Sept. Price shown is assembled and tested for now.

Has external START STOP inputs, they can be either contacts or a voltage but not a mixture of the 2. Input voltage of up to 48 volts for the trigger and down to 3 volts,selectable by onboard jumper, The low range is good up to 13 volts in, the high range is for 12 volts to 48.

Also has the ability to use dry contacts, set the jumper for contacts and use any dry contact to control the timer.

Easy to set seconds minutes and even hours. Perfect for simple timing tasks. Use for any application that requires simple cycling timer.

The On time adjust has a 1 to 250 range, for seconds this can be divided by 10, to make setting 15 seconds easy.

The range can be 1 to 250 minutes, or minutes multiplied by 10 for 2500 minutes. This works out to just over 41 hrs.

Power supply, 12 volts DC at 30 mA, both contacts are available, Normally open and Normally closed.