DC DC STEP DOWN WITH METER

SKU
LM2596S-STEP-DOWN-MTR
In stock
$6.95
  • Buy 2 for $6.49 each and save 7%
  • Buy 5 for $6.25 each and save 10%
-
+
Overview

High efficiency switching regulator. DISCONTINUED. REPLACED BY XL4015-3D

Uses an LM2596S step down converter IC to create a regulated DC output. On board LED DC voltmeter makes for a simple solution when you need an efficient voltage regulator.

Meter error 0.1V Range 0~40V. (Note: When the input voltage is below 4V, the on-board meter does not work)

With the touch of a button you can switch the meter input to input or output voltage measurement, an indicator shows which side your measuring, input or output and it keeps the last setting, even when powered off and on again.

The voltmeter can be turned off, press the switch for 1 second or more and less than four seconds, let go, meter is off.

Has screw terminal connections for input and output. No soldering required to use this module.

Works from 4 VDC to 40 VDC and it has 1 volt drop so if you need 15 VDC you need at least 16 VDC.

The output voltage is adjustable from 1.25VDC to 37 VDC using a 10 turn trim pot.

The maximum output current is 3A, continuous and stable operating current of 2A or less is best.

The switching regulator has an operating frequency of 150 KHz.

Even has a way of calibrating the meter if something goes a miss, hold the switch for more then 4 seconds, now you're in the calibration mode. Adjustable by 0.1 of a volt 0.5 to -0.5 of a volt.