2 Ch Learning IR Receiver Ver 2.0

SKU
VK038
In stock
$34.95
-
+
Overview
Two 10 amp SPST relays on a small PCB form a simple remote control. Good for 5 amps per connection.
ASSEMBLED & TESTED

Use almost any IR remote to control our new 2 channel relay card, works in momentary or toggle mode, each channel can be set to the desired mode, fits our case G203C with a clear lid for simple mounting and robust protection from its environment, while giving feed back VIA the on-board indicator LEDs. THE IR detector is good up to 8 meters or 25 feet. The relays are rated up to 10 amps but keeping the current under 5 would be best. If you need more current just drive another larger relay.


Shown Mounted in OPTIONAL case. Enclosure NOT included



Shown with clear lid. Case shown is NOT included with the VK038

Requires a 12 volt DC power supply, has provisions for barrel power connection 5.5mm outer 2.1mm inner positive center, or 2 screw terminals for your altrenate energy setup or power something else with your extra current.


Current draw is less then 50 mA with both relays on.
Perfect for Automotive use.
Relay outputs have a 2 pole screw terminal connection.
Use for your home theater room, add a motor to your screen, keep it clean when not in use.

The case lid can be sealed with a rubber gasket to make it water resistant , however all holes need to be drilled on the downward facing side, in order to allow the connections and still provide water protection.

The case has 2 holes for mounting the case to a wall or cabinet, they are then covered by the lid once installed.

Enclosure shown: G203C is not included. Order Here: G203C