Barometric pressure sensor BMP180

SKU
GY-68-BMP180
In stock
$4.95
  • Buy 3 for $4.75 each and save 4%
-
+
Overview
Barometeric pressure sensor, mounted on a small PCB, 5 pin male header, not soldered in place.

Add atmospheric pressure sensing to your next project using the BOSCH BMP180 sensor, trying to mount this device by hand risks damaging the device. There is a 3.3 volt regulator mounted on the PCB to make sure that the I2C sensor has stable power. 2 x 4K7 resistors are tied to Vcc to pull up the data and clock lines. The header pins are not mounted on the PCB to make it easier to mail. If you do not like to solder, just mention in the order notes that you would like it soldered in place. The board has 2 mounting holes.

 

I2C communication, 5 volt power supply input, the device is 3.3 volts.

 

The output of this regulator is now available as a header pin, however loading of this regulator could affect stability, use it wisely Luke!

 

Here is a link to the DATA SHEET Happy sensing! James

 

If you have something you would like to add, feedback or a code snippet drop me a note.