GPS Receiver with Serial Output uses NEO-6M

3.3 Volt module with on board regulator.

The IO signals are 3.3 volt, however the module requires 5 volts DC to supply the on board 3.3 V regulator. The output is serial however these are logic level and not RS232 compatible.

In order to setup the module for use you need to run U-BLOX setup

You will need a USB to serial converter Click Here.

Use this module with your Arduino or Arduino Clone or Raspberry Pi or even Banana Pi all of which are available from QKITS.

Adrunio UNO will require a bit bang serial port or software emulation or use a MEGA which has 4 serial ports.