Installs between the windshield wiper switch and wiper motor. Can be used in any car.

Gives your car the "intermittent" wipe mode, instead of either having the wipers on or off. Installs across the low speed circuit of the wiper motor. Use the normally open contacts to supply the slow speed circuit. The timer will turn on for a few seconds then turn off. The wiper postion will determine the off delay. The park contact should supply the wiper motor until the wiper makes a complete cycle. If not then this kit will probably not work for you, its easy to determine just shut the wipers off while they are in the middle of the cycle. If it returns to park position then your all set.

ON OFF switch is incorprated into the speed adjust.

LED indicator for the state of the relay.

This is a fully assembled and tested module.

The circuit board dimensions are 50 mm or 2.64 inchs by 58 mm or 2.22 inchs and aprox 16.5 mm or .65 of an inch high. The PCB has four mounting holes one in each corner of the PCB. The pot has an on off switch incorporated and it would be possible to add a short length of wire (100 cm or aprox 36 inchs 5 wires in total) to remotely mount the control.

Keep in mind that there are far to many wiring configurations for us to be able help with all installs. It would help if you already have the necessary background and are able to think for yourself. Basically this is just like a switch that goes across the low speed switch.