The Stepper Motor Chopper Driver Kit is a Bipolar Stepper Motor Drive with easily adjustable current control up to 2A, based on the SGS-Thompson L297 and L298 stepper motor controller and driver ICs.

Assembly Required!

While the motor turns you can simultaneously check the status of the dry-inputs (ex. emergency stop signal, limit detection...).

KTA-193 or KT-5193A

The Modbus Programmable Stepper Motor Controller is a four axis multifunction programmable stepper motor controller which utilises the modbus protocol for communications.

KTA-196 or KT-5196A

This Bipolar Stepper Motor Controller is Microcontroller Based.
Controls 4, 6 and 8 wire Stepper Motors
Full and Half Stepping Modes

KTA-197 or KT-5197A

You simply write ascii commands through the PC's serial port to the card to control each of the stepper motors

Connects to the PC serial port and provides an easy to use interface for connecting and controlling stepper motors by your PC.

Small 1, 2 or 3 axis stepper motor drivers with full, 1/2, 1/4 and 1/16 micro-step modes.